Packet tracer configuring dhcp using cisco ios
What am I probably doing wrong? I'm using Cisco Catalyst I was assigned a task to configure an SG300-28P to have 3 different vlans. The uplink to the AP is set as a trunk port, PVID 1, uplink port is also a member of VLAN 20 and Vlan 40 but untagged for all VLAN traffic. I have 5 Cisco SG-300 and 1 Cisco SG-500 switches. Connect your computer to the Cisco Ethernet Switch using an Ethernet cable. On cisco 3750 there is no VLAN created, every FE0/ port has Public IP and goes to internet. The SG300-20 is connected to an Asus RT-AC66U router on the 192. I have 8 vlan configure in SF300 (SVI with ip address)isit possible to configure dhcp server and how i can apply access-list to restrict with other vlans. We currently have a single Cisco SG300 switch on our data network. Sub-interface configuration and IP address assignment on the router. One subnet has a small number of machines which use static ip addresses, here there are no problems. Now, poke around a bit on the web interface.
![packet tracer configuring dhcp using cisco ios packet tracer configuring dhcp using cisco ios](https://usermanual.wiki/Document/813320Packet20Tracer2020Configuring20DHCPv420Using20Cisco20IOS20Instructions.236125926-User-Guide-Page-2.png)
Meraki DHCP reservations and settings can be tricky though if you switch between enabling/disabling VLANs.
![packet tracer configuring dhcp using cisco ios packet tracer configuring dhcp using cisco ios](https://i.ytimg.com/vi/gAel_p0OQiE/maxresdefault.jpg)
Home › Forums › Networking › Cisco Routers & Switches How-to › Setting up DHCP for SG300-10 VLAN This topic has 9 replies, 5 voices, and was last updated 6 years, 2 months ago by digconmd.
PACKET TRACER CONFIGURING DHCP USING CISCO IOS SERIES
As an administrator, you can configure your Cisco 800 series router to act as a DHCP server, providing IP address assignment and other TCP/IP-oriented configuration information to your workstations.